3D model of felixthecrazy
The models were repaired and checked for printability.
WARNING: Parts of this model are very fragile! I made this for a model to sit on
...Zeig mehr the shelf not to be played with.
All parts but the CloudBase will need to be printed an additional time mirrored in your slicer.
Assembly: Feed the Masts into the sail rings and then feed them into the MastBase one by one. The mirrored MastBaseMount will need to be shaved down a little to fit flush against the ship hull. The lower most rivets on the ships keel will need to be shaved off to fit in CloudBase.
https://www.facebook.com/FelixTheCrazy
