3D model of iczfirz
The models were repaired and checked for printability.
Yet another easy printable and usable mask. The shape of this design will cover your
...Zeig mehr chin. Design inspired by an antique TLR. First prototype equip with two extended hooks for strap which looks like the aperture and shuttle dials. Now is a bit too sci-fi.
Added 3M and Moldex filter cartridge support
[ Breathing Valves | Print time 2.25hrs | inout Filter | 22g | 7-sizes | Remix Template | Future Module Upgrade ]
Why will I not design this mask for printing in PLA or PETG?!
I get quite a few requests to convert this design for printing in PLA or PETG. Sorry, but I am not going to do that, and this is why:
In my experience, PLA and PETG are TOO DANGEROUS to put on your face. If a PLA or PETG mask cracks, especially when printed as a light weight/thin wall, it will cut your face like a knife. It may not be happen on the first day, but it will happen one day, maybe while you are talking, and it will be sudden. Thin walled PLA and PETG will fatigue much faster than TPU, being washed, dragged and pulled in daily use. Maybe something hits your mask while you are wearing it, and it splits or shatters.
That is why I don't want to convert this design to use PLA/PETG. It is for your safety.
Print and use it at your own risk.
Uses up to 10mm thickness Filter. Mask weight 22gram.
Key features of this design include:
-Separate inlet and outlet valves prolong the lifespan of the intake filter.
(humidity of exhaled breath always shorten the filter life)
-By design the flexible mask will fit on any face. (Or use hairdryer and scissor for best fitting)
-100% infill so no hollow structure,
-Modular System for future extension.
-Remix template for makers
Only ever use filters you trust. Wash the mask in soapy water for 20 seconds or more when you remove it. Remember that if the filter has protected you against COVID-19, then the virus is now on the outside of the mask or in the filter media, and it can still contaminate you unless/until you kill it first, in soapy water. All in all, I believe your satisfaction with this mask should be limited only by the skill with which you make it, and not by any features of the design.
Good Luck everyone and my love.
Loose sew two discs. Snap on all parts together. (To seal with glue or not? It’s always depends on the makers' handcraft but it is not necessary by design.)
Printer:
Bed Size 120 and up
Rafts:
No
Supports:
No
Resolution:
0.1-0.3mm
Infill:
100%
Filament brand:
Any
Filament color:
Any
Filament material:
TPU + {PET-G / PLA}
Print Settings (Setup new Profile base on stock Extra Fast 0.3mm base profile)
-Custom
Profile
-Extra Fast -0.3mm
Layer Height
-0.3mm
Initial Layer Height
-0.2mm
Wall Thickness
-1.2mm
Fill Gaps Between Walls
-Nowhere
Seam Corner Preference
-None
Infill Density
-100%
Build Plate Temperature
-20degC
Build Plate Temperature Initial Layer
-50degC
https://www.instagram.com/iczfirz/
