Quick connect for the RC4WD / JD Models / Eagle Machinery 870k wheel loader.
UPDATE: new "plate.stl" now with more servo support.
UPDATE 2: New
...Zeig mehr "AccApapterBiggerHook.stl" part with more hook to avoid "popping off" with heavier loads - thanks Chris for your testing!
To comlete you will need to following:
* 6mm stainless rod (Amazon): https://www.amazon.com/gp/product/B072JPQX4Q
* Spring set (Amazon): https://www.amazon.com/gp/product/B07RFH9Y74
* Flanges on the end of the locking rods - I had a buddy tig weld some washers on there. As shown in the photo, these are ~33mm long.
* I used a Hitec HS-85MG+ but you could use another similarly sized servo - you'll need to cut up a horn to fit in the recess under the cam part.
* 16 Stainless M3x10mm screws, counter-sunk. I think they are all 10mm in length, but if you get the assortment from amazon, you're sure to have several lengths, 4 nuts (again the assortment will also have nuts).
Assembly is pretty straightforward.
Its fairly strong for what it is, but I make no promises for long-term longevity. The only metal one that is available is quite expensive, then you either have to hack up your stock bucket or buy new one(s).
I may design a bucket, it would be interesting to see how long one would last if it were printed out of nylon or something else that is stronger than pla.
