870k Wheel Loader Quick Coupler RC4WD JD Mode

Modell von
Gravatar image
loading...
Modellbeschreibung
Quick connect for the RC4WD / JD Models / Eagle Machinery 870k wheel loader.

UPDATE: new "plate.stl" now with more servo support.
UPDATE 2: New...Zeig mehr "AccApapterBiggerHook.stl" part with more hook to avoid "popping off" with heavier loads - thanks Chris for your testing!

To comlete you will need to following:
* 6mm stainless rod (Amazon): https://www.amazon.com/gp/product/B072JPQX4Q
* Spring set (Amazon): https://www.amazon.com/gp/product/B07RFH9Y74
* Flanges on the end of the locking rods - I had a buddy tig weld some washers on there. As shown in the photo, these are ~33mm long.
* I used a Hitec HS-85MG+ but you could use another similarly sized servo - you'll need to cut up a horn to fit in the recess under the cam part.
* 16 Stainless M3x10mm screws, counter-sunk. I think they are all 10mm in length, but if you get the assortment from amazon, you're sure to have several lengths, 4 nuts (again the assortment will also have nuts).

Assembly is pretty straightforward.

Its fairly strong for what it is, but I make no promises for long-term longevity. The only metal one that is available is quite expensive, then you either have to hack up your stock bucket or buy new one(s).

I may design a bucket, it would be interesting to see how long one would last if it were printed out of nylon or something else that is stronger than pla.
Über den Autor des Modells
Gravatar image
No uploads
Genehmigtes Profil