3D model of jeremy8077
The models were repaired and checked for printability.
I took nazaff's awesome Pusheen lamp, shrunk it down, imported it into
...Zeig mehr TinkerCad, duplicated it, shrunk the duplicate, made the smaller duplicate a hole and used it to hollow the bigger of the two. Then I made a 60mm hole in the bottom.
I printed it using opaque light blue PLA at .2 layer height with no infil and one shell. It does not require support, but a raft helps.
Thanks nazaff! I made this for a friend of mine...she seemed happy with it!
Thanks for looking!
Printer brand:
MakerBot
Printer:
MakerBot Replicator
Rafts:
Yes
Supports:
No
Resolution:
.2
Infill:
0%
Notes:
I used one shell.
http://twitter.com/Jeremy8077
