3D model of fine_engineer
The models were repaired and checked for printability.
"Such a larg bounty for such a small package"
"Buy yourself a
...Zeig mehr camtono of spice"
"This is the way"
This is a Camtono from Star Wars as seen in Episode 3 season 1.
Its fully operational, all 3 flaps can be opened and locked by turning the upper lid.
Scale is for 6" figures but you can scale it to 200% for 12" HotToys figures.
Also I added some beskar pieces to fill it.
Scaling down to 66% for 3.75" figures is not recommended as the hinges are very small and sensitive even at 6".
This is a very small thing, but nevertheless took me some time to print and optimize, so drop me a like and consider giving me a tipif you love the design. Thank you.
Printing:
Print at highest quality: 0.1mm layer are highly recommended. The parts are oriented in the right direction to print, don´t turn them. For the body you need supports, set to "touching buildplate". Removing them after printing is difficult, so take your time so that you don´t break the body. I recommend to split the support in the middle with pliers and carefully lift it with a small screwdriver and pliers. I set the layer between support and part to 0.2mm, which makes it somewhat easier. I found the surface over the support a bit rough, but thats just fine as it looks a little bit like carpet on the bottom of the camtono, which fits fine. The rest of the parts are very easy to print.
Assembly:
See the picture for reverence. Inserting the door through the openings on the side is a little bit like a puzzle. Clue the lid to the lock, but not to the body, as lid and lock should be turned to lock the flaps.
Use a 1mm diameter wire and cut three piecess of 9mm for the hinges. If you have problem getting them through the holes or if they are not printed open heat a thin needle over a candle and carefully! open them with the hot needle.
