3D model of 300zxcolin
The models were repaired and checked for printability.
My first upload so apologies if I've made any mistakes!
THIS IS A WORK IN
...Zeig mehr PROGRESS! Check back to find additions.
Based on the Star Wars pod racers but imagined in a more refined way.
The engines and winglets are from Bold Designs "Margos Dog Eddie" with the wings shortened for the main wings and resized for the front spoiler.
Designed on 123D Design.
Some parts require support.
I printed the canopy then shrunk a plastic bottle over it to make a clear canopy, hence I've supplied a pilot if you want to go this route. Otherwise just paint the canopy black.
I haven't include any registration holes or pins so its up to you how you attach parts.
Also the rear fin top pin wouldn't print due to it's small diameter so I used a barbeque stick.
Model comes out at about 400mm long and will fit most print beds.
I use a CTC makerbot clone.
https://www.facebook.com/300zxcolin
