3D model of vandragon_de
The models were repaired and checked for printability.
Let's go on another search and rescue mission. To support this task, I present
...Zeig mehr SAR that is optimally prepared for it. It swims very well and has a small dinghy for direct support which can be quickly lowered into the water.
So that there is also something to rescue directly, it is recommended to print out the life raft as well. Thus the fun of playing can begin.
Even if my boats are not benchmarks (benchy), you can use them for quality control.
Although it is a lot of fun to draw boats and bring them to life, it takes a lot of time to research and draw. Especially the 1:1000 scale models are very time-consuming.
Printer brand:
Prusa
Printer:
i3 MK2S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
40% / 15%
Notes:
To ensure that the boat floats optimally, it is recommended to print the red keel with 40% infill. The rest should then be printed with 15% infill.rnrnLayer divisions at Slic3r, which was inserted in the Gcode after the export with M600 command.rnrnFilament change - layerrnrnWhite from Layer - 13.00rnOrange from Layer - 38.00rnWhite from - 43.00rnOrange from - 52.20rnWhite from - 57.60
https://www.instagram.com/vandragon_de
