3D model of vandragon_de
The models were repaired and checked for printability.
Growth for my bathtub fleet. A little tugboat.
I had seen a great 3d picture of a
...Zeig mehr tugs and I couldn't get that out of my head. Unfortunately, I don't know where I saw it. So I tried to draw it out of my head. The model was created on this basis.
Even if my boats are not benchmarks (benchy), you can use them for quality control.
I drew two versions. One with open cabin and one with closed. The highlight of the open version is a variation of Larry the Engineer (Makerbot) as captain. The tug can be used on land, then you don't have to pay attention to anything. However, if it is to be floatable, the fuselage must be printed with two different fillings. Otherwise the boat is too light.
Bottom: 40-50% Infill
Top: 10% Infill
The models on the pictures are printed with 70% of the original.
Minor bugs fixed, thanks to Melchiorus
Although it is a lot of fun to draw boats and bring them to life, it takes a lot of time to research and draw. Especially the 1:1000 scale models are very time-consuming.
Printer brand:
Prusa
Printer:
i3 MK2 MMU
Rafts:
No
Supports:
No
Resolution:
0,15
Infill:
50% / 10%
Notes:
If it shall swim, two different infill
Bottom: 40-50% Infill
Top: 10% Infill
Fillament:
orange: Janbex
green: Janbex
red: fillamentum
blue: fillamentum
https://www.instagram.com/vandragon_de
