Make #16 - Book Owls von Johnnn_3d

Modell von
loading...
Modellbeschreibung
3D model of faberdasher
The models were repaired and checked for printability.

These helpful little owls mark your place in a book or hang happily on your tree....Zeig mehr Owl good is that?!

Slice with 2 shells (/perimeters) and 0% infill. At coarse resolution (0.3mm), you will find prints have extra shimmer (and print quicker!).
Created in stunning Faberdashery Robot Silver PLA^ and Bling Bling Gold PLA^.

This print requires ~10g of material (~2m of 3mm / ~4m of 1.75mm filament).

Simply print and bookmark. Or hang. Or both! You have two, so why not?
https://twitter.com/faberdasher
Über den Autor des Modells
75 models uploaded
Genehmigtes Profil