3D model of turbo_sunshine
The models were repaired and checked for printability.
This is my Print in place spring loaded box design! No supports, no assembly,
...Zeig mehr just print and use!
All clearances are 0.3mm or greater, so most household 3d-printers should have no problems printing it. however, if you suspect you might need a little tuning, I did include a test piece to tune your printer!
Important:
-Use 0.2mm layer height or finer! (this is due to the overhang being designed for it)
The print should be positioned on its side as shown in the video during printing. (gears down)
-No Suport
Rafts:
No
Supports:
No
Resolution:
0,2mm
https://www.instagram.com/sunshine_turbo
