MAGNETIC Chainmail Wallet! -Single print! von Alexander_3d

Modell von
loading...
Modellbeschreibung
3D model of turbo_sunshine
The models were repaired and checked for printability.

After having a lot of success with my Chainmail wallets, I decided to update the...Zeig mehr link design ever so slightly and make it accommodate 6x3mm magnets!

This version requires you to pause the print at the correct layer height, then glue in the magnets, and afterwards continue the print for a seamless wallet.

I have included 2 test pieces;
-The magnet test, is to test your printers ability to pause and resume a prints.
-The Zipper test is used to dial in the necessary amount of Horizontal expansion compensation for the best fit, I use -0.07mm on my Ender-3
https://www.instagram.com/sunshine_turbo
Über den Autor des Modells
33 models uploaded
Genehmigtes Profil