3D model of davision3d
The models were repaired and checked for printability.
The Mood Cube comes in 6 faces each representing one mood a human lifeform can
...Zeig mehr experience.
Each of the faces gets printed on its own and afterwards all 6 gets assembled into the Mood Cube. This procedure has been made easy with a snapping mechanism that keeps everything of the Mood Cube in place.
No support required!
Please note: this is a exact replica of the ancient artifact. Any curses might be replicated with it. I can not be made responsible if it devours all your emotions and holds them inside for eternity.
You could also put a light inside (This could include paper and/or aluminum foil on the inside)
Hang it up somewhere (There is a extra piece to put inside on which you can connect a nylon twine for instance. Make sure it holds well enough before you hang it up! You could also print 4 pieces to hang it leveled.)
Put it on a print able pedestal (See the zip file)
Hang only a face on a wall (Holes to hang it up included on the backsides).
I used 0.2 for the silver regular small one and 0.3 for the 150% bronze one.
I do not recommend printing smaller since the connections will likely not work at a smaller size. Theoretically brigger than 150% should work but I have not tried that myself with the improved connections.
Assembling:
First of all it will not hold together with just 2 or 3 pieces, only with all 6 pieces it will hold strongly together. Try to hold 2 together with one hand then place a third piece and then make sure you grab all 3 with one hand to then proceed with the 4th piece and so on.
Opening:
Opening the Mood Cube can be tricky, try to grab as many pieces as you can on a corner and drag them outwards. Do this on a table because the cube can disassemble into all its pieces. In case it is too hard to get open try to use 2 butter knives (The ones that are not sharp)
http://twitter.com/TocoGamescom
