3D model of sebtheis. The models were repaired and checked for printability.
I edited the head in order to print the eyes in separate parts. I made a square hole
...Zeig mehr in the eye in order to look like bender's eyes. I was much inspired by R3ND3R's custom eyes for the bender figure.
Add some black marker pencil in the eye pupil and the head is perfect.
you will also find the jaw part with custom supports, it is now super easy to print this part.
Also note that I scaled up the parts by 2540% in order to correct Simonarri's export in inches.
In order to make a really poseable figure :
use a thin metallic wire. Heat it with a lighter and insert it in the feet (same with hands and head).
drill a small hole in the center of the links (or make a hole with a heated wire)
drill and glue the other end of the wire in the firstlinks (same with hips)
Hint: if your eyes are hard to fit in the head, scale them down just a little.
have fun!
Printer brand:
RepRap
Printer:
prusa i3 custom
Rafts:
No
Supports:
No
Resolution:
0,1mm
Infill:
30%
https://www.facebook.com/themakerscult
