3D model of uwcharlie1983. The models were repaired and checked for printability.
This a T-bar style jewelry display for bracelets. It can be used at home or to
...Zeig mehr display bracelets that are for sale.
The bar is one inch in diameter, eight inches wide and is four inches above the base. The base is six inches by two and a half inches.
If you lay this part on its back it can be printed without supports. I printed it with 10% infill.
Printer brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Supports:
No
Resolution:
0.1 mm
Infill:
10%
Notes:
It is helpful (but not necessary) to glue a small amount of ballast to the inside front of the base to make the display more stable.
