Castle Stairs von Tom_3dmodels

Modell von
loading...
Modellbeschreibung
3D model of prettysmallthings. The models were repaired and checked for printability.

Every damsel (or witch, warlock or astronaut) needs a grand entrance. Add a...Zeig mehr grand entrance to your Makerbot Fairytale Castle playset! 1:18 scale.

Or, test the overhang capabilities of your machine instead. The print has quite the overhang!

Instructions
The castle stairs print plate requires a 110x110x110 print area. The full castle stairs requires a 115x100x210 platform to fit full scale.

No support required. A fan is recommended to reduce curling. I printed with 2 extra shells and 25 mm/sec on my TOM Mk7, and ran into a little layer separation due to running my extruder temp a little too low. The test prints were good, but I have not attempted prints of the final files. Please report any problems you might encounter.

Print the "floor" files included here to replace the "Floor B" files included with the original Makerbot Fairytale Castle. Use the provided image as a guide for building your castle staircase.

The staircase itself was created in AutoCAD and a DWG is included here. A revision of Skimbal's Sketchup file is included with the required floor alterations.
@KacieHultgren
Über den Autor des Modells
46 models uploaded
Genehmigtes Profil