I wanted a rear xt60 plug mount option, this is a first attempt not sure if it will out out or not might need some tweaking. You can also add your antenna on the
...Zeig mehr back to max transmission, intended for long range long axii. It's got a tilt but i'd be f*cked what i set it at :P 20-30 ish
VTX mount is meant to raise the vtx above the power leads to use the space it hooks up to the 2 mid post in the rear and grabs on to the frame. I will try update as its a bit snug but can widen.
RX holder goes on mid front post, it can hold the immortal T it has a curve on the bottom to sit on my cap. The cap i used it a massive 50v 1000uf that i accidentally bought so just using them up. The immortal T hits the ground but it was meant to go back to it's original straight characteristics upon launch. This is trial so it COULD DAMAGE if you skid or land on hard surfaces. It's also a first draft. need to add more meat to capture more of the T handle so it stays put :P
I am a tinkerer with no training, use these as they are functional to me but not pretty if your going for looks :P My prints are shit because i can't figure out how to get my printer to work function properly so if i post pics and they look crap that's my inexperience on printing.
Added rear one piece SMA and GPS mounting plate, V3 uploaded. Seems the SMA holder was a bit close so moved the post holes forward to give you an extra 5mm. Should be enough. Let me know if it needs to be modified again. I lost my 399 at our local river so i do not have a frame to check it against ;)