Kailh switch opener

Modell von
Gravatar image
loading...
Modellbeschreibung
This is a simple tool that you can use to open up kailh switches. In its current state it requires two ~20mm m3 screws to assemble.

Edit: a new file called...Zeig mehr thicker wedge has been added. This piece works a lot better and causes the top housing to pop off rather than just loosening it.

Edit: I would not recommend printing the wedge in its current orientation. Instead, try rotating it 90 degrees so that the large flat side is on your print bed.
Über den Autor des Modells
Gravatar image
No uploads
Genehmigtes Profil